Omada EAP225 Deployment Configuration Suggestions
I am looking for general recommendation on deployment for the EAP225's around a family farm. I have ordered 3 of these currently and they should all be within around 100m of each other. I did see online that it is not suggested to go over 180m in distance between them. One of the EAP's will be installed on a house, one installed on a barn and these two will have line of sight. Finally one will be installed on a shed surrounded by metal grain bins with no line of sight between either the House or Barn EAP's for now. Side note for the Shed EAP there is a spot I can mount it so it has line of sight with the barn in the future but will still be surrounded by grain bins as it is getting to cold to run cable outside. I did decided to buy the OC200 controller as well for the cloud functionailty ease and since I am hoping this can turn into a broader solution in the future to allow the installation of poe cameras in some hard to reach areas and provide wireless access to a handfull of devices as well if this works out. The House EAP will be the one with the router/wan connection while the Barn EAP, and Shed EAP will be connected via mesh. Currently the wireless dBm is bad between the EAP's (70+ to 80+ range) since the only ones properly mounted to the side of the buildings are the Barn and Shed EAP's. The House EAP is sitting in the house currently behind a window since it got too cold to run the cable outside the other day. As I said before I am expecting the Shed EAP for the time being to remain with poor signal quality due to location. Currently there will not be much of a load on the EAP's since for now I am just trying to just get basic connectivity between the buildings.
Any notes or suggestions that someone has from trying to do something similair in the real world would be a big help and much appriciated.
Also if I have posted this in the wrong forum or if my spelling is bad I do apologize and thank you.