Help Omada Topology

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Help Omada Topology

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Help Omada Topology
Help Omada Topology
2021-12-02 13:53:29 - last edited 2021-12-07 07:02:41
Model: TL-SX3016F  
Hardware Version: V7
Firmware Version:

Hi,

sorry I am new, and I would like your help for check my topology and the devices before to buy.

I would like to setup and speed network 100% manage by omada.

The internet come from WAN/LAN1. Really I will use about 9 switches but for simplify I show you only 4.

My concert is if I am usgin right the Switch SPF+ TL-SX3016F

 

Devices:

https://www.tp-link.com/es/business-networking/all-omada/

 

Switch TL-SX3016F

Router ER7206

Switch TL-SG3428XMP
Controller OC 300
Cable SPF TL-SM5220-1M
Transceptor TL-SM5110-SR

 

 

Network:

 

 

 

thanks so much.

 

 

  0      
  0      
#1
Options
3 Reply
Re:Help Omada Topology
2021-12-02 13:55:12 - last edited 2021-12-07 07:02:41

@jhon7 picture details

 

  0  
  0  
#2
Options
Re:Help Omada Topology
2021-12-03 05:42:57 - last edited 2021-12-07 07:02:41

@jhon7 

What's the point of using sg2210P while it has an SFP port? You're running SFP+ for the rest of your network? 

 

(maybe you need your local network fast? then, that makes sense)

  0  
  0  
#3
Options
Re:Help Omada Topology
2021-12-03 07:13:56 - last edited 2021-12-07 07:02:41

Dear @jhon7,

 

jhon7 wrote

sorry I am new, and I would like your help for check my topology and the devices before to buy.

I would like to setup and speed network 100% manage by omada.

The internet come from WAN/LAN1. Really I will use about 9 switches but for simplify I show you only 4.

My concert is if I am usgin right the Switch SPF+ TL-SX3016F

 

Welcome to TP-Link Business Community!

 

The TL-SX3016F switch is usually used in the core layer of a middle-sized business network, while the TL-SG2210P switch is normally used in the access layer. May I know your application scenario and your purpose of the topology? What devices will be connected to the downlink TL-SX3016F switches?

 

If you just want to connect the ER7206 router to the first TL-SX3016F switch, you may use a Media Converter like MC200CM to replace the TL-SG2210P (with a 1G SFP slot) and one 10G SFP Cable TL-SM5220-1M.

 

As you may find that there is no Ethernet port on the TL-SX3016F switch, if your end clients are some Ethernet devices, you may replace the downlink TL-SX3016F switches with a TL-SG3428X or a TL-SG3428XMP (it supports PoE out). By the way, using Ethernet Cat5e or above cable should be enough.

 

Hope the information above helps.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#4
Options