Business Community > Controllers > unable to login to omada hardware device ER605, i am able to login via controller
< Controllers

unable to login to omada hardware device ER605, i am able to login via controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

unable to login to omada hardware device ER605, i am able to login via controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
unable to login to omada hardware device ER605, i am able to login via controller
unable to login to omada hardware device ER605, i am able to login via controller
2022-03-04 17:02:20 - last edited 2022-03-15 02:55:08
Model: Adapter  
Hardware Version: V1
Firmware Version: 1.2.0

I am not able to login to router, i need to change the WAN interface speed and duplex.

 

i am able to login to Omada controller. How to login to device and change the speed and duplex?

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:unable to login to omada hardware device ER605, i am able to login via controller-Solution
2022-03-04 22:37:58 - last edited 2022-03-15 02:55:08

  @iDeepu 

 

Hey

 

When controlled by a controller the speed on the WAN port is set to auto-detect

 

If it is connecting at 100mbps then check the port on the connected device is set to / capable of 1000mbps.   This is likely an issue on the Modem / Router you have attached to the ER605

 

Also ensure the cable is cat5e or newer to ensure a 1gb connection

Recommended Solution
  1  
  1  
#2
Options
2 Reply
Re:unable to login to omada hardware device ER605, i am able to login via controller-Solution
2022-03-04 22:37:58 - last edited 2022-03-15 02:55:08

  @iDeepu 

 

Hey

 

When controlled by a controller the speed on the WAN port is set to auto-detect

 

If it is connecting at 100mbps then check the port on the connected device is set to / capable of 1000mbps.   This is likely an issue on the Modem / Router you have attached to the ER605

 

Also ensure the cable is cat5e or newer to ensure a 1gb connection

Recommended Solution
  1  
  1  
#2
Options
Re:unable to login to omada hardware device ER605, i am able to login via controller
2022-03-14 20:44:51
Yes that worked, the moment i used cat6 it started working. I belive the cable which i had was cat4.
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 547

Replies: 2

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.