Omada SDN nearly bricked my router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi there, i have my ER605 router all configured appropriately for my location using the built-in UI. When i went to my server where i had the Omada SDN installed, and went to Adopt the router, it kept switching between Adopting to Configuring, and it kept going back and forth. It got to a point where i couldn't access the router at all from my configured settings, and after watching it switch back and forth for 20mins, with my Internet being down the entire time, i had to do a factory reset of the router and reload my config file back in. I haven't tried to do the Omada setup again, because i would like to keep my pre-configured settings. Did i do something wrong, or does the Omada setup wipe all settings out of the router by default? Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
No sadly there is not
Generally there the controller is much easier to configure than the router GUI. You should be able to open the 2 windows side by side and copy / compare the changes / passwords etc across.. done that before!
Once configured on controller, just adopt her and should be good
- Copy Link
- Report Inappropriate Content
Adopting the router will wipe/remove any locally configured settings and apply the settings you have supplied via the controller. Others have experienced issues adopting a router that was heavily configured, its better to adopt the router when its factory reset / untouched.
On your controller, under settings > wired networks > internet configure your router ISP setting there. Then factory reset the router and adopt it via the controller, it will then configure the setting you have supplied to the controller.
- Copy Link
- Report Inappropriate Content
Hi @mknabster
To assist you efficiently, I've forwarded your case to the TP-Link support team who will contact you with your registered email address later.
Please pay attention to the email box for follow-up. Thank you so much for your cooperation and patience.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
If you are using a controller (hardware or software, they are the same) configure your Internet settings in admin / wired networks / internet then adopt the controller (ideally with no config on it)
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
No sadly there is not
Generally there the controller is much easier to configure than the router GUI. You should be able to open the 2 windows side by side and copy / compare the changes / passwords etc across.. done that before!
Once configured on controller, just adopt her and should be good
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 735
Replies: 8
Voters 0
No one has voted for it yet.