Controller Backup to FTP; cannot use Hostname

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Controller Backup to FTP; cannot use Hostname

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Controller Backup to FTP; cannot use Hostname
Controller Backup to FTP; cannot use Hostname
2022-05-04 15:42:20 - last edited 2022-05-31 09:18:02
Model: OC200  
Hardware Version: V1
Firmware Version: 5.1.7

In the latest Hardware Controller firmware 5.1.7, there's a new option to backup to an FTP server. See screenshot.
Well, there seems to be a bug in the interface. When specifying a server, it clearly states "Server Hostname/IP:"  However, the text field only allows IP address input. There's no way to add a hostname.

I will start using this feature immediately if I could use a hostname (which resolves through Cloudflare, so the IP is not always the same).

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Controller Backup to FTP; cannot use Hostname-Solution
2022-05-31 09:17:44 - last edited 2022-05-31 09:18:02

Dear @supermarkert,

 

supermarkert wrote

In the latest Hardware Controller firmware 5.1.7, there's a new option to backup to an FTP server. See screenshot.
Well, there seems to be a bug in the interface. When specifying a server, it clearly states "Server Hostname/IP:"  However, the text field only allows IP address input. There's no way to add a hostname.

 

Thank you for your valuable feedback!

It's confirmed that the subsequent Controller v5.4 will add the configuration for Server Hostname. So stay tuned for updates.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Controller Backup to FTP; cannot use Hostname-Solution
2022-05-31 09:17:44 - last edited 2022-05-31 09:18:02

Dear @supermarkert,

 

supermarkert wrote

In the latest Hardware Controller firmware 5.1.7, there's a new option to backup to an FTP server. See screenshot.
Well, there seems to be a bug in the interface. When specifying a server, it clearly states "Server Hostname/IP:"  However, the text field only allows IP address input. There's no way to add a hostname.

 

Thank you for your valuable feedback!

It's confirmed that the subsequent Controller v5.4 will add the configuration for Server Hostname. So stay tuned for updates.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options