omada router not adopting

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

omada router not adopting

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
omada router not adopting
omada router not adopting
2022-05-07 01:40:50 - last edited 2022-05-09 00:55:42
Model: ER7206 (TL-ER7206)  
Hardware Version: V1
Firmware Version:

hello,

i have a small network running consisting of a OC200 and a 8 port POE switch. running 2 AP and printer from this and it works well. Getaway is a standard comcast / Xfinity 10.0.0.1.

 

i want to adopt a OMADA router to get more functionality. put the getaway in bridge node and connected the router and hoped it would adopt which did not happen. i guess this is because the controller is on the 10.0.0.xx network and not connecting to the router default 192.168.0.1. However, the system recognizes the router but adoption fails.

 

Is there an easy way to fix this other than reseting all devices and set up system from scratch?

 

caM i connect localy to the router and change to 10.0.0.1 and then connect to the network?

 

Thank you.

  0      
  0      
#1
Options
2 Reply
Re:omada router not adopting
2022-05-09 08:15:47

  @wondering 

That's right, you will need to modify the router IP in standalone mode first.

 

Here is an instruction

  0  
  0  
#2
Options
Re:omada router not adopting
2022-05-09 15:48:43 - last edited 2022-05-09 15:50:39

  @wondering 

 

You have a relatively small network and your APs should be DHCP configured anyways by the OC200.  Should be a simple matter to reconfigure the IP of the printer if it's static.

 

My recommendation is spend the extra few minutes to move your system over to the 192.168.0.x network, it really shouldn't be a big deal and will make your life easier in the future (like if you ever replace the router)

 

Here are my thoughts on how I'd do it, system will be offline:

 

1. power up the factory-reset Omada router in standalone mode  (let's assume you'll have router at .1, switch at .2 and oc200 at .3)

2. attach your laptop to the LAN port and log into router and configure a Fixed IP for the MAC address of the OC200 (or skip this step and figure it out later from the attached clients list on the router)

3. unplug the laptop and attach the switch to the router's LAN port, then login to your oc200 at it's new 192.168.0.x:8043 address

4. Edit your LAN subnet from 10.x.x.x to 192.168.0.x/24 on the Controller and add Fixed IP mappings for your switch, the OC200 and your APs and printer if desired

5. power cycle the router, switch and oc200

6. log back into your OC200 at it's new fixed ip and adopt the router

7. Verify that AP's have come up with 192.168.0.x addresses and wirelessly attached clients can ping the router (192.168.0.1)

 

You can connect the gateway in either router or bridged (preferred) mode to the WAN port of your Omada router now.  You probably want to configure WAN for a IPv4 Dynamic IP which should be the default.

 

 

 

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 556

Replies: 2

Related Articles