[5.3.1] Legend for device TL-SG2008P
Hi,
In Omada controller, legend for TL-SG2008P is pretty extended, as I understand, I can't have more than 1000Mbps per port.
Why legend prints color codes for more than 1000Mbps ?
From other hand, I have TL-R605 on same controller and it shows it properly, max 1000 Mbps and proper in legend:
So, can you put some consequence here ?
Thans
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
There are currently 2.5 and 10gbps switches available for purchase and therefore these speeds appear as legends in the switch settings, they will only be useful to anyone with that specific hardware. The routers however are all only 1gbps ports (no 2.5 / 10gb yet) and therefore they havent added these to the legend for the router section.
Its likely you will see faster ports on the router on the controller when there is hardware to support it
- Copy Link
- Report Inappropriate Content
This is misunderstanding. Following this idea - there are 16 ports and 24 ports switches, but you are displaying only 8 available in SG2008P. I think legend for device should contain only information needed for this device not for other devices.
- Copy Link
- Report Inappropriate Content
There are currently 2.5 and 10gbps switches available for purchase and therefore these speeds appear as legends in the switch settings, they will only be useful to anyone with that specific hardware. The routers however are all only 1gbps ports (no 2.5 / 10gb yet) and therefore they havent added these to the legend for the router section.
Its likely you will see faster ports on the router on the controller when there is hardware to support it
- Copy Link
- Report Inappropriate Content
This is misunderstanding. Following this idea - there are 16 ports and 24 ports switches, but you are displaying only 8 available in SG2008P. I think legend for device should contain only information needed for this device not for other devices.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 690
Replies: 2