2
Votes

Colour code device states

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
 
2
Votes

Colour code device states

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Colour code device states
Colour code device states
2022-05-09 15:14:17
Model: EAP225-Outdoor  
Hardware Version: V1
Firmware Version: 5.0.5

Applies to all Omada hardware.  Seems to make sense to me to code

 

RED - inactive/offline

YELLOW - undergoing management/transition/update (ie service interruption expected)

GREEN - active and passing traffic normally.

 

 

So in the above, I would expect 'Configuring' to be yellow (as I would Adopting and Provisioning and Updating) unless traffic is being passed normally.  We can argue about whether Isolated is yellow or red :)   I would say red as it would transition shortly to a yellow state once the mesh re-converges and then green, but should stay red if it cannot rejoin.

 

 

<< Paying it forward, one juicy problem at a time... >>
#1
Options