ER605 Disconnects
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello, I'm having issues with my router disconnecting from my network on a regular basis. The disconnects don't seem to cause connectivity issues for clients or other Omada switches or APs at first but eventually, the whole network falls apart unless I reboot the router. Today I encountered the issue and it seems the router is disconnecting every hour at the same time. Any ideas on what might be causing this issue?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Short update.
TP-Link has released a new firmware (v. 2.1.1) that the support advised me to upgrade to. In the release notes there are a lot of bug fixes so I hope that this issue is resolved now.
One thing I noticed after upgrading is that the router admin portal no longer supports Brave browser. It works with Chrome and Firefox but not Brave which I have been using previously. Not a big deal but something to be aware of.
- Copy Link
- Report Inappropriate Content
Still getting multiple router connect messages with the latest firmware
- Copy Link
- Report Inappropriate Content
Connect messages still appearing on one of two ER605v2 I have.
Two ER605v2 with an IPSec VPN tunnel between then, both PPoE WAN Connections
At one end connected messages spamming the logs, at the other end it is fine, no connect messages.
Upgrades went through no issues, took about 10 minutes each end.
- Copy Link
- Report Inappropriate Content
Hi all,
i have finally returned my ER605V2 and replaced with an ER7206 since 1 week and what to say, except i have no more any connect/disconnect message in the log. Averything is now working as it should be.
- Copy Link
- Report Inappropriate Content
Short update.
Today the router disconnected again with the newest firmware (2.1.1). Needed to reboot the router to get Internet access again. It worked for 12 days this time, but the problem is the same, can access Internet from WAN side but not from LAN side.
- Copy Link
- Report Inappropriate Content
There's another thread on this, basically you need to schedule a reboot every week for the ER605. Disappointing that the latest firmware didn't fix this (sounds like a memory leak or other failure to release resources issue to me).
- Copy Link
- Report Inappropriate Content
That would be great, if the ER605 had a built-in reboot feature. I don't use an OC200 or software controller.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
WalrusWW wrote
That would be great, if the ER605 had a built-in reboot feature. I don't use an OC200 or software controller.
@WalrusWW FYI. According to the release notes for the 2.1.1 firmware the ER605 has now scheduled reboot in standalone mode:
From: https://static.tp-link.com/upload/firmware/2023/202301/20230130/ER605(UN)_v2_2.1.1%20Build%2020230115%20Release%20Note.pdf
21. Add Reboot Schedule in Standalone mode.
- Copy Link
- Report Inappropriate Content
I have a V1, and just updated to the newest beta firmware 1.2.1, and don't see a reboot schedule option anywhere. Maybe it's just for the V2
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 25921
Replies: 123
Voters 0
No one has voted for it yet.