Can't access one website
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi all,
Feels kinda stupid, but I have problems accessing 1 certain website. It's doing a couple of hops and the times out. It's works at other locations (like home or parents home) without Omada.
I already tried to duplicate the MAC address, read an article on the internet about that, but I didn't have any access to the internet any more after that.
I have a dutch cable internet supplier called Ziggo and when they disabled the bridge mode and I tried to access the website via their standard wifi and then it was accessible again.
Thanks in advance!
==================
- omada oc200
- ER605 v1.0
- TL-SG2210P v3.20
- EAP610(EU) v1.0
@Bartolini Hi
I did not see same issue on my system.
Which connection type did you use on tplink router? If that is PPPoE, try configure the MTU to 1480 or lower.
If you are using Dynamic IP, then on the same page enable "Unicast DHCP"
I don't know if this is a clue or a 'red herring'...but the IPv6 address for the efk site is malformed IMHO (I'm no expert on v6 though!). Normally IPv6 is 6 groups of 4 hexadecimals, so 1234:5678:90ab:cdef:1234:5678 and any subgroup that is all zeros can be ommitted, ie 1234:0000:0678... would show as 1234::678:...
compare the resolves for efk vs google and ibm below
Is there anyway to force the end client to only operate in IPv4?
