This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I configure the following ACL to allow only ARP and IPv4 traffic:
> Jetstream#show access-list > MAC access list 100 name: "Allow IP" > rule 10 permit logging enable type 0800 > rule 20 permit logging enable type 0806 > > Jetstream#show access-list bind > ACL ID ACL NAME Interface/VID Direction Type > ------ -------- ------------- -------- ---- > 100 Allow IP Gi1/0/23 Ingress Port
Yet IPv6 traffic flows freely through the specified port.
What must be configured so that the ACL works as intended?
Dear @Fae
Ok, I successfully flashed the previous firmware to the TL-SG3428X, and am now using it until the new version is released. Thanks and regards!
Dear @Fae
when can we expect the new firmware for the TL-SG3428X to be available for download, will it be soon? 
Thanks!
Helpful: 0
Views: 1979
Replies: 13
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
