Wired EAP235-Wall as mesh uplink?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wired EAP235-Wall as mesh uplink?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wired EAP235-Wall as mesh uplink?
Wired EAP235-Wall as mesh uplink?
2022-09-11 17:48:08

Can the eap235-wall be configured to act as an uplink device for a mesh connected AP (EAP225-outdoor)?

 

The mesh network has been configured through the Omada controller but the EAP-outdoor will only connect through the wired EAP610 as the uplink. Even if I enable auto failover and disconnect the EAP610, the meshed outdoor AP just disconnects, despite the wall AP being much closer and active.

 

Am I simply incorrect in thinking the EAP235-wall was capable of being an uplink device within a (partial) mesh network?

  0      
  0      
#1
Options
1 Reply
Re:Wired EAP235-Wall as mesh uplink?
2022-09-12 19:16:46

  @TrungH 

 

For some unknown reason, none of the wall units support Mesh.  Would be nice, hint hint.

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#2
Options