Business Community > Routers > ER605 in an old network
< Routers

ER605 in an old network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 in an old network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 in an old network
ER605 in an old network
2022-12-29 20:35:15
Tags: #WAN Setup #Gateway IP address
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version:

I have a bad ISP router that I am about to replace with ER605. The old router has IP address 192.168.1.1 and I have many clients, 15-20 of them with fixed IP addresses that I don't want to change.

As I already have a Omada AP (EAP653) it would be convenient to use the Omada Controller SW in my desktop PC for configuration and maintenance.

The problem is the default IP address of the ER605, 192.168.0.1. In order to work in my old network it need to be 192.168.1.1.

I came so far that the Omada Controller recognizes the EAP653, with corredct old IP, and the ER605 with its default address, but I can't change it.

How do I proceed?

  1      
 
  1      
 
#1
Options
3 Reply
Re:ER605 in an old network
2022-12-30 08:35:32

  @Borjebus 

 

You can just connect a PC to router with an Ethernet cable like this: Router----PC.
Then set a static IP address like 192.168.0.10 on this PC.
And try to ping router's default IP address 192.168.0.1.

 

How to set static IP address
How to ping
 
If you can Ping this IP address successfully, use 192.168.0.1 to log into the router's management page.
And now you can change the setting as you want.

 

Just striving to develop myself while helping others.
  1  
  1  
#2
Options
Re:ER605 in an old network
2022-12-30 14:40:56 - last edited 2022-12-30 14:41:26

  @Virgo Yes, I  was able to ping the "new" IP address. Unfortunately I have forgotten the login :(. I tried the Reset button in the front, but it didn't help.

How can I get the unit back to Factory default?

  0  
  0  
#3
Options
Re:ER605 in an old network
2023-01-02 12:29:41 - last edited 2023-01-07 15:41:43

By pressing the reset button a little longe I managed to get it back to factory settings and set a new login. Today the Omada Controller has adopted my two devices and taken control. Now it's up to me to learn how the Controller works.

  0  
  0  
#4
Options

Information

Helpful: 1

Views: 2267

Replies: 3

Tags

WAN Setup
Gateway IP address
Related Articles
Cannot ping ER605 from outside network
1776 0
Need help configuring ER605
645 0
ER605 Standalone network segregation
513 0
ER605 as a second router in network
4316 0
When to upgrade the old version of ER605 v1 to use "Full mode for OpenVPN"
1831 0
Port Forwarding ER605
1617 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.