ER605 - Reset to factory default

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 - Reset to factory default

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

nightfever

2023-02-09 10:12:17 - last edited 2023-02-09 10:13:17

Posts: 12

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2020-12-11

ER605 - Reset to factory default

2023-02-09 10:12:17 - last edited 2023-02-09 10:13:17

Model: ER605 (TL-R605)

Hardware Version: V2

Firmware Version:

I made a setting in standalone mode back then, which is not accessible via controller mode (SNMP / Get trusted host IP).

So my idea was to forget the router and re-adopt to get rid of this setting. The manual says forgeting means reseting. So, is it really that easy: forget (=reset to default ?) an re-adopt? Or is there anything to consider?

1 Reply

d0ugmac1

LV5

2023-02-09 15:33:39

Posts: 2126

Helpful: 776

Solutions: 193

Stories: 0

Registered: 2022-03-05

Re:ER605 - Reset to factory default

2023-02-09 15:33:39

@nightfever

If the router is currently managed, then 'Forgetting' it via the controller interface will cause it to do a factory default (reset). It should then re-appear as an available device for adoption and this time around your SNMP command will not get pushed.

Alternatively, if you are NOT managing it with a software controller, you will need to do a the factory default through the web interface, or via the reset button.

Either way, that SNMP setting will not be persistent afterwards.

<< Paying it forward, one juicy problem at a time... >>

ER605 - Reset to factory default

ER605 - Reset to factory default

Information

Voters 0

Tags