Wireguard Site2Site Routing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wireguard Site2Site Routing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wireguard Site2Site Routing
Wireguard Site2Site Routing
2023-03-02 15:12:53 - last edited 2023-03-07 08:35:08
Model: ER7206 (TL-ER7206)  
Hardware Version: V1
Firmware Version: Beta

Hi

I have successfully set up a Wireguard Site2Site connection in Omada with the er7206 and the Beta software I can also ping the tunnel ip of the Omada from the Pfsense and also go data back and forth however I do not know how to set the routing in Omada because there is neither a gateway to select except wan or the normal networks and Nexthop also does not work. Has someone an idea?

  0      
  0      
#1
Options
2 Reply
Re:Wireguard Site2Site Routing
2023-03-02 15:27:28 - last edited 2023-03-07 08:34:52
A Restart helps and now Pings are possible an no roting needs to config
  0  
  0  
#2
Options
Re:Wireguard Site2Site Routing
2023-03-03 03:23:00 - last edited 2023-03-07 08:34:52

  @Godanet 

i find a strange problem with the omada series. if you upgrade the firmware of the gw, you usually have to manually reboot it and make it work flawlessly again. 

I've seen port forwarding, vpn and all kinds of stuff relates to nat that requires a manual reboot to put them back to normal status. 

this should be a reminder in the release note. after the reboot of the firmware upgrade, do it again manually. 

ScReW yOu gUyS. I aM GOinG hoMe. —————————————————————— For heaven's sake, can you write and describe your issue based on plain fact, common logic and a methodologic approach? Appreciate it.
  1  
  1  
#3
Options