Adopt loop with EAP225-Outdoor

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Adopt loop with EAP225-Outdoor

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Adopt loop with EAP225-Outdoor
Adopt loop with EAP225-Outdoor
2023-04-07 19:34:58 - last edited 2023-04-09 12:43:19
Model: EAP225-Outdoor  
Hardware Version: V1
Firmware Version: 5.0.5

Running Software Controller v5.9.31  and getting a Adopt/Provisioning loop. Was also getting the same thing on eap670 but beta firmware 1.0.6 fix it. Is there a beta firmware for EAP225-Outdoor as well?

 

I've tried:

1.  'forget' wait 10+ minutes and retry but same issue.

2. Rebooting the device during the provisioning and adopting stage. 

3. Disabling both radio's during the 'provisioning' stage.

4. Disabling all WLAN groups during the 'provisioning' stage.

 

Still getting loops.

 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Adopt loop with EAP225-Outdoor-Solution
2023-04-09 12:43:16 - last edited 2023-04-09 12:43:19
Thanks. I see that 5.08 is available - this fixed the issue!
Recommended Solution
  0  
  0  
#5
Options
4 Reply
Re:Adopt loop with EAP225-Outdoor
2023-04-08 15:08:21
Which controller and version?
<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#2
Options
Re:Adopt loop with EAP225-Outdoor
2023-04-08 15:11:03

  @d0ugmac1 

 

it's in my post.

  0  
  0  
#3
Options
Re:Adopt loop with EAP225-Outdoor
2023-04-08 15:16:19
My mistake. I know that the 225-outdoors is up to 5.0.9 in my region, I also know that 5.0.5 is using the old Omada config port range and 5.9 controllers use the new. Could be an issue there.
<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#4
Options
Re:Adopt loop with EAP225-Outdoor-Solution
2023-04-09 12:43:16 - last edited 2023-04-09 12:43:19
Thanks. I see that 5.08 is available - this fixed the issue!
Recommended Solution
  0  
  0  
#5
Options