TP Link ER7206

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP Link ER7206

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP Link ER7206
TP Link ER7206
2023-04-20 09:16:40 - last edited 2023-04-25 03:17:11
Model: ER7206 (TL-ER7206)  
Hardware Version: V1
Firmware Version: 1.2.0

Hello

 

I have get big problems now with my er7206, its rebooting all over, several times every day,

 

i have test different firmware ( 3 latest), have reset it several times, checked the settings lite 1000 times.

 

i have test with SFP port and no change, starting to lose my maid here :(

 

and i cant find eny error report or message from the router.

 

So how can jag proceed?

  0      
  0      
#1
Options
1 Accepted Solution
Re:TP Link ER7206-Solution
2023-04-24 09:08:03 - last edited 2023-04-25 03:17:11

i think i have fixed the problem, i did reset the hole shabang... lite much to handle but i only did tek 1 day to get all to worked agin :)

 

So i did reset all my gear.

 

1st ER7206

2st SG2008P

4st EAP225

1st EAP 653

2st EAP 610

4st SG105PE

 

i didn't what to use my backup when i didn't now what caused the problems, so now i just hope it works :)

Recommended Solution
  0  
  0  
#9
Options
8 Reply
Re:TP Link ER7206
2023-04-20 12:09:28

  @Gronis 

 

So there is absolutely nothing curious in the logs?  If not, my guess would be a power supply issue.

 

 

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#2
Options
Re:TP Link ER7206
2023-04-20 12:25:03

  @d0ugmac1  Hello

 

i run controller 200 så i don't find the picture you showing me, ER7206 don't have any power supply that i can change, only one kabel, 

  0  
  0  
#3
Options
Re:TP Link ER7206
2023-04-20 12:43:14

  @Gronis 

 

Ok, so the OC200 version looks like:

 

 

 

Sounds like you are running your OC200 via POE..which means you must have a POE switch in your setup as well?

 

I would keep the 5.7.6 firmware on the OC200 for now, forget and then re-adopt the ER7206.  If that doesn't work, you can try factory defaulting the OC200 (take a backup first) and rebuild a minimal config to get you back up and running again (ie WAN settings, LAN settings, leave ACLs, port forwards for now...this is just a stability test), then factory reset the ER7206 and do a clean adoption.

 

Since the ER7206 has an AC input, if there is a PSU issue it will be internal and not user fixable.  The only suggestion I have here is bring power from another circuit somewhere with an extension cord in case there is some 'noise' on the current plug/circuit (like a big motor starting up (fridge, freezer, furnace...) or a welder or....??)

 

The quickest fix may be just to purchase a new 7206 if you are unable to resolve by defaulting and rebuilding the soft configuration.

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#4
Options
Re:TP Link ER7206
2023-04-20 13:15:26 - last edited 2023-04-20 13:20:28

the picture is the same that i have. i have tested 3 latest firmware on 7206 i have resettet it sevral times i have testat whith an without SFP module i have put a fan that blows air on it 7206 i dont have tested any firmware in OC200, it runs 5.7.6 yes i have 4 poe switchs and they work, its only the router that ceep rebooting. and i cant faind any logs that can be the router problems and what i can remember i havet chage anyfhing on my setup i moths

 

 

only one thing i can rember that i have done now is put upp nginx proxey manager, can that mess upp my router?

  0  
  0  
#5
Options
Re:TP Link ER7206
2023-04-20 13:28:43

  @Gronis 

 

Well, it sounds like a hardware fault then.  Recommend you open a support ticket with TPlink to confirm.

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#6
Options
Re:TP Link ER7206
2023-04-20 17:38:11

  @Gronis 

Looks like the ER7206 comes with a Limited Lifetime Warranty.  That at least is good news.

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#7
Options
Re:TP Link ER7206
2023-04-21 06:36:56

I have change the router now to my old er605 V2 and its working now, so my 7206 is prtobley broken :(

  0  
  0  
#8
Options
Re:TP Link ER7206-Solution
2023-04-24 09:08:03 - last edited 2023-04-25 03:17:11

i think i have fixed the problem, i did reset the hole shabang... lite much to handle but i only did tek 1 day to get all to worked agin :)

 

So i did reset all my gear.

 

1st ER7206

2st SG2008P

4st EAP225

1st EAP 653

2st EAP 610

4st SG105PE

 

i didn't what to use my backup when i didn't now what caused the problems, so now i just hope it works :)

Recommended Solution
  0  
  0  
#9
Options

Information

Helpful: 0

Views: 583

Replies: 8

Related Articles