Using OC200 ad locally controller (without cloud)
Using OC200 ad locally controller (without cloud)
Hello,
I need a Wireless Lan Controller for 6 APs (TP-Link EAP) but I dont like the cloud services.
I would be use the OC200 only locally.
Internet is required for OC200?
Can I only use the controller locally?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
The OC200 is capable of local-only operation (it doesn't not need internet or cloud resources to do the AP control). Normally it just lives in your Management VLAN.
Of course, you may also want to actively discourage/prevent it from reaching the internet (some ACL's should take care of any attempt to reach out to the world).
- Copy Link
- Report Inappropriate Content
The controller is needed for Fast Roaming, but whether the switch is managed or standalone should not matter. All the magic happens between the AP and the Controller.
- Copy Link
- Report Inappropriate Content
The OC200 is capable of local-only operation (it doesn't not need internet or cloud resources to do the AP control). Normally it just lives in your Management VLAN.
Of course, you may also want to actively discourage/prevent it from reaching the internet (some ACL's should take care of any attempt to reach out to the world).
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@d0ugmac1 your suggest is much appreciate! I need to discover this tips to design well the solution.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@z3n0 The switches are the most solid part of the Omada solution, so no issue there.
For a hardware controller, you have the OC200, OC300 standalone options the 7212 router+switch+controller. You can make your own hardware controller with a VM, Container, or even Raspberry Pi
The 2008P is perfectly fine, I use them often.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
The Omada switch must have "Controlled mode" active to allow OC200 of manage the network or it can be work with STandalone mode? I would like that OC200 manage only the EAP and they roaming.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1826
Replies: 20
Voters 0
No one has voted for it yet.