Mounting
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
@Gii in usual fashion TPlink gives mixed info on this. The MAP section in OMADA lets you set the direction of the device LED when you place your APs. If you follow that guideline, with the 110 LED being on the side, it shows the coverage area being 90 degrees off. For example one of my EAP110 OD is facing East, which puts the LED facing North. If input the LED facing north as it instructs, it shows the covered area being north and south, which I am willing to bet is not the case.
I would stick with the face (logo side) and back being the primary directions of coverage. Disregard the icon for the AP, it does not represent actual oreintation. The logo is facing east but I input north as the direction of the LED.
@Gii in usual fashion TPlink gives mixed info on this. The MAP section in OMADA lets you set the direction of the device LED when you place your APs. If you follow that guideline, with the 110 LED being on the side, it shows the coverage area being 90 degrees off. For example one of my EAP110 OD is facing East, which puts the LED facing North. If input the LED facing north as it instructs, it shows the covered area being north and south, which I am willing to bet is not the case.
I would stick with the face (logo side) and back being the primary directions of coverage. Disregard the icon for the AP, it does not represent actual oreintation. The logo is facing east but I input north as the direction of the LED.
