EAP245v3 Mesh in Standalone Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP245v3 Mesh in Standalone Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP245v3 Mesh in Standalone Mode
EAP245v3 Mesh in Standalone Mode
2023-05-28 16:53:16 - last edited 2023-05-30 16:43:22
Tags: #Mesh
Model: EAP245  
Hardware Version: V3
Firmware Version: 5.1.0

Hi,

 

I have two EAP245 v3 with the newest Firmware. In the release notes you wrote 

"Add support for Mesh feature in Standalone mode (Requires Omada APP v4.6.x or above)."

 

How to set this up?

 

Currently I have one EAP245 as AP on my wired Network and the other EAP245 is atm not in use.

I want to use it as Mesh Repeater without an OC200. Is this possible?

 

Thanks

  0      
  0      
#1
Options
1 Accepted Solution
Re:EAP245v3 Mesh in Standalone Mode-Solution
2023-05-30 06:39:26 - last edited 2023-05-30 16:43:22

Hello @Bensch,

 

You may refer to this FAQ on the official website to set the Mesh network in Standalone mode.

How to configure your EAP access points into a Mesh Network using the Omada App

Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:EAP245v3 Mesh in Standalone Mode-Solution
2023-05-30 06:39:26 - last edited 2023-05-30 16:43:22

Hello @Bensch,

 

You may refer to this FAQ on the official website to set the Mesh network in Standalone mode.

How to configure your EAP access points into a Mesh Network using the Omada App

Recommended Solution
  0  
  0  
#2
Options
Re:EAP245v3 Mesh in Standalone Mode
2023-05-30 16:41:27
Thanks, that worked. I forgot to reset my Main AP on my first try with the Omada App.
  2  
  2  
#3
Options

Information

Helpful: 0

Views: 393

Replies: 2

Tags