Home

Forums

Stories

Knowledge Base

Business Community > Controllers > EAP610 outdoor disconnect in Controler after Firmwareupdate

< Controllers

EAP610 outdoor disconnect in Controler after Firmwareupdate

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP610 outdoor disconnect in Controler after Firmwareupdate

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

13 Reply

AlvaroGR

LV1

2023-07-10 19:06:54

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-07-10

Re:EAP610 outdoor disconnect in Controler after Firmwareupdate

2023-07-10 19:06:54

@Hank21 Hi, I've experienced same issue after upgrading to firmware 1.1.3. How do I downgrade to previous version? I do only have a MAC laptop and the Omada app. No Windows or Linux. Thank you for your support.

#12

Obrenner

LV2

2023-07-11 06:29:03

Posts: 26

Helpful: 8

Solutions: 0

Stories: 0

Registered: 2020-07-08

Re:EAP610 outdoor disconnect in Controler after Firmwareupdate

2023-07-11 06:29:03

@AlvaroGR

you Van do Thais with an MAC Laptop.

reset eap

connect your MAC wireless to the EAP

configure your EAP as standalone eap with the wizard

configure your Wireless Connection to the 192.168.0.x ip and Connect to it

downgrade Firmware you have downloaded befor from tp-link

after Thais you can adopt the eap.

thats the steps i have done with my MacBook

#13

Hank21

2023-07-12 01:46:56

Posts: 3673

Helpful: 718

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:EAP610 outdoor disconnect in Controler after Firmwareupdate

2023-07-12 01:46:56

Hi @AlvaroGR，

You may downgrade the firmware through two methods below:

1. Go to EAP Details window, Click on Config > Manage Device > Custom Upgrade, and click on Browse to upload the 1.1.3 firmware version. (Please confirm the account you used to log into the Controller is the Main/Master Administrator.)

2. You can also choose to Forget the EAP to get it back to the Standalone page via Config > Manage Device > Forget. Then upload the file on the EAP web interface:

After upgrading, adopt the EAP again on the Controller.

If there is any stuck issue during the upgrade process, you may try the Firmware Recovery to fix it.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

#14

EAP610 outdoor disconnect in Controler after Firmwareupdate

EAP610 outdoor disconnect in Controler after Firmwareupdate

Information

Voters 0

Tags