EAP650-Wall downlink port specification
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi
I would like to find out some specifications about the EAP650-Wall downlink port. I can't find anything about that port in the general manual for access points ("Omada Access Points_User Guide(EU&US") on the support page.
- Can the port be disabled?
- Can I enable VLAN for the port? In that case, what type of VLAN functions are available? MAC VLAN?
- Is it a PoE port?
1. No, you can not disable the port.
2. Yes, you can set the PVID for the ETH port.
3. I'm afraid it doesn't support, you should see these"One port supports PoE OUT. The PoE OUT feature requires 802.3at PoE+ input and the maximum output is 13 W." if it supports, but it hasn't on the spec.
1. No, you can not disable the port.
2. Yes, you can set the PVID for the ETH port.
3. I'm afraid it doesn't support, you should see these"One port supports PoE OUT. The PoE OUT feature requires 802.3at PoE+ input and the maximum output is 13 W." if it supports, but it hasn't on the spec.
