ER7206 IPSEC Site-to-Site - no incoming traffic

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER7206 IPSEC Site-to-Site - no incoming traffic

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER7206 IPSEC Site-to-Site - no incoming traffic
ER7206 IPSEC Site-to-Site - no incoming traffic
2023-11-07 02:17:37 - last edited 2023-11-16 06:10:43
Tags: #VPN
Model: ER7206 (TL-ER7206)  
Hardware Version: V1
Firmware Version: 1.2.3 Build 20221104 Rel.41500

Hi,

 

I have just set up a new ipsec site-to-site tunnel to a remote Edgerouter ER4.  I can initiate outgoing traffic without issue.  I cannot however receive traffic initated at the remote end.  I have tried disabling all firewall default settings I could find.  Are there any other things I should check?

 

Note that this is a dual WAN setup if that makes any difference.  The tunnel is setup to use WAN1 on the ER7206.

  0      
  0      
#1
Options
1 Accepted Solution
Re:ER7206 IPSEC Site-to-Site - no incoming traffic-Solution
2023-11-07 02:55:56 - last edited 2023-11-07 08:24:39

disregard, the solution to this was a simple reboot.  Always a bit odd why it's required when things worked in one direction, but at least it appears solved.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:ER7206 IPSEC Site-to-Site - no incoming traffic-Solution
2023-11-07 02:55:56 - last edited 2023-11-07 08:24:39

disregard, the solution to this was a simple reboot.  Always a bit odd why it's required when things worked in one direction, but at least it appears solved.

Recommended Solution
  0  
  0  
#2
Options