Hi @DerFredl 

Thanks for posting in our business forum.

This is not LAG.

Do you mean this?

Floor 1 - SG108E

                    |

Floor 2 - SG108E

 

Unless you use two cables between the SG108E, then you need to set up the LAG.

Just cascading them in the map above does not require LAG.

 

LAG needed:

Floor 1 - SG108E

                    | |

Floor 2 - SG108E

Hello Clive, the picture #2 shows the actual situation between both floors, there are two CAT5e network cables that can be used for it. For me, it seems possible to connect e.g. the cables to the ports #7 & #8 of the switch in floor A - and on the floor B (for easier understanding) also to the ports #7 & #8 of the switch located there. Is there a sample how to configure the switches properly for this? It would be fine if I can use other ports (e. g. #1 - #4) of the switches locally. Best Regards and thanks for help!

Hi @DerFredl 

Thanks for posting in our business forum.

User Guide

You can refer to this - Chapter 4 LAG.

 

Hi @Clive_A, thanks for the link, I will study the guide!