inconsistency between documentation and ETH Port Settings.
When looking at the documentation 8https://static.tp-link.com/upload/image-line/EAP615_Wall_1.0_03_large_20210827080338k.jpg) is not matching the view when i look thru OC200 Device/EAP615/Config/Advance/ETH Port Settings
---
ETH Port Settings
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @AntonV,
Thanks for your valuable feedback! This has been forwarded to the developer team for attention and is planned to be optimized in the subsequent firmware iteration.
- Copy Link
- Report Inappropriate Content
Hi @AntonV
Thanks for posting in our business forum.
Here's the way to verify it.
EHT0 is the uplink, right? If you set up VLAN on the upstream switch/router, you don't bother to configure anything on this uplink port.
So, you configure ETH1 with another PVID X(except for 1), and you test it out on ETH1. Will you get the IP from the VLAN X?
This should verify what worries you and answer itself.
- Copy Link
- Report Inappropriate Content
@Clive_A Yes, I could actually figure out thru one youtube video (just to make sure that i am setting the right one). Point here is more that documentation/manuals/etc. need to be consistent thru GUI, pdfs, pictures.
thank you.
Clive_A wrote
Hi @AntonV
Thanks for posting in our business forum.
Here's the way to verify it.
EHT0 is the uplink, right? If you set up VLAN on the upstream switch/router, you don't bother to configure anything on this uplink port.
So, you configure ETH1 with another PVID X(except for 1), and you test it out on ETH1. Will you get the IP from the VLAN X?
This should verify what worries you and answer itself.
- Copy Link
- Report Inappropriate Content
Hi @AntonV,
Thanks for your valuable feedback! This has been forwarded to the developer team for attention and is planned to be optimized in the subsequent firmware iteration.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 235
Replies: 3
Voters 0
No one has voted for it yet.