Hi @HPE 

Thanks for posting in our business forum.

Did you set it to be a tagged port? PC does not accept tagged traffic.

Hi @HPE 

Thanks for posting in our business forum.

HPE wrote

Hi Clive, i have it setup as a interface port not a VLAN port. Is this what you are meaning?

Yes. Same thing. VLAN interface, then you set it as a tagged port? Tagged with a VLAN ID? Change it to untagged with VLAN ID + PVID to get the desired VLAN IP or untagged VLAN 1.

Hi @HPE 

Thanks for posting in our business forum.

HPE wrote

  @Clive_A thanks for getting back to me. I have attached the screenshot of the settings to show you. The VLAN is ID 1 and there is still the issue.

 

It is really hard for me to squeeze things out of you in this format. Email or forum should be a place where you give enough detailed information. Yet this is not going well.

I thought you were saying everything under the context of the standalone. If it is the controller, I don't know if you are familiar enough with the controller. Read the User Guide first. I don't really know what you have changed and what caused this.

You come to the forum looking for an answer, so why not go to the support and speak about everything you have done before the issue pops up?

This picture means nothing to me. It just means you did not remove the port from the VLAN 1. The system does NOT support to remove ports from VLAN 1.

And why would you set the gateway to 172.16.1.94?

If you don't know what you are doing, reset the router and controller, and start over. It's your config issue.Or provide the step notes about everything you've changed. I'll find out the fault.

Have you read this before you post?

And this?