Port forwarding issue
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Port forwarding issue
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I am trying to replace an archer a7 with this er605 and am having an issue forwarding all the port on the network. I have spent hours searching these forums and google and nothing I do is working. I have gone to transmission>Nat> virtual server and filled out the standard required information like I have done many times in the last decade. I cannot detect any open ports. The previous router port forwarding was working so I am confident the pc firewalls are ok. I read also that the router ACL needed to be set to allow the virtual server through. I think that I have set this correctly, but this is a new step in my experiance in setting up PF. What am I doing wrong or is this just the router having issues?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
It should be working... this is the frustrating part.
- Copy Link
- Report Inappropriate Content
I can only suggest you factory default the router, set it up again, and configure only the DMZ pointing at your internal server. I have seen situations where these routers get a bad config and just can't escape without the reset.
- Copy Link
- Report Inappropriate Content
@d0ugmac1
The issue was a filtering device called Bark. Once I turned it off forwarding acted like it should. Thanks for your insites.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1322
Replies: 13
Voters 0
No one has voted for it yet.