Omada hardware controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada hardware controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada hardware controller
Omada hardware controller
2024-01-22 08:03:39
Model: OC200  
Hardware Version: V2
Firmware Version:

My Omada hardware cannot be powered by POE. What could be the problem?

 

  0      
  0      
#1
Options
3 Reply
Re:Omada hardware controller
2024-01-22 08:52:41 - last edited 2024-01-22 08:54:49

  @Ronokip Have you tried a different Ethernet cable?

 

What kind of switch are you using? Is the switch with the capability of PoE at the bare minimum?

 

According to the spec sheet, OC200 uses

 

Power Supply 802.3af/at PoE or Micro USB(DC 5V/1A)
 
  0  
  0  
#2
Options
Re:Omada hardware controller
2024-01-22 10:08:35

  @YuukiA  yes I have changed several ethernet cables and its not working

  0  
  0  
#3
Options
Re:Omada hardware controller
2024-01-23 04:21:30

  @Ronokip 

 

We assume you are connecting your POE source to the leftmost port labeled Eth1?

 

We also assume you are able to power other POE devices with the cable end your are trying to use for the OC200?

 

Assuming your cable is good and in the correct port, the only remaining options are the pie source being the wrong voltage, a poe injector is reversed, or the oc200 is actually defective or damaged.

<< Paying it forward, one juicy problem at a time... >>
  2  
  2  
#4
Options