Omada hardware controller
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My Omada hardware cannot be powered by POE. What could be the problem?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Ronokip Have you tried a different Ethernet cable?
What kind of switch are you using? Is the switch with the capability of PoE at the bare minimum?
According to the spec sheet, OC200 uses
| Power Supply | 802.3af/at PoE or Micro USB（DC 5V/1A） |
|---|
- Copy Link
- Report Inappropriate Content
@YuukiA yes I have changed several ethernet cables and its not working
- Copy Link
- Report Inappropriate Content
We assume you are connecting your POE source to the leftmost port labeled Eth1?
We also assume you are able to power other POE devices with the cable end your are trying to use for the OC200?
Assuming your cable is good and in the correct port, the only remaining options are the pie source being the wrong voltage, a poe injector is reversed, or the oc200 is actually defective or damaged.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 421
Replies: 3
Voters 0
No one has voted for it yet.