Omada: Which (PoE-) device is connected to which LAN port?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada: Which (PoE-) device is connected to which LAN port?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada: Which (PoE-) device is connected to which LAN port?
Omada: Which (PoE-) device is connected to which LAN port?
2024-02-29 08:21:54 - last edited 2024-02-29 10:46:11
Model: ER7212PC  
Hardware Version: V1
Firmware Version: 1.1.2 Build 20240102 Rel.50640

Hello!

i. e. EAPs have a view 'Clients', where I can see, which Clients are connected to a certain EAP.
The ER7212PC has a view 'Ports' (see attached screenshot), but it does not show, which devices are wire connected to which LAN port.
Also the devices (such as EAP, laptop, ...) do not know, to which LAN port they are connected.

It would be very useful for switching on/off PoE devices ('ER7212PC / Config / Advanced / Enable PoE'; see other screenshot), if there was at least some information, which device is connected to which LAN port.
How can I find out using the inbuilt Omada controller, which device is connected to which LAN port?

Kind regards,
Gerald

File:
Screenshots.zipDownload
  0      
  0      
#1
Options