@spd2612 

vlan1 can only changed IP, all other change to whatever you want 

  @MR.S 

well I did get the oc200 configured in the oc200

4 wan connections show connected

and 4 Vpn subnets

but when I plug more then one of the vlan ports into my netgear 48 port smart poe switch lights on the router er8411 and the switch start blinking fast and I loose all connections

this does not happen in stand alone mode 

i have done many resets to get this far Any Ideas what I may be missing

  @Hank21 

My wans which are 4 are all configued this way

This is VLAN20 which was the default and I changed it but I cant change the Lan interfaces on it oc200 WONT ALLOW IT I use this lan as a main one and for management

This goes out to the switch on lan5 port Is it possible that this is the issue because these are all selected

If it is I dont know what to do as I cant do anything with the default

This is VLAN30 which I can change the Lan interfaces and its output to the switch is on LAN6   I have a total of 4 vlans

  @Hank21 

actually its connected using 4 cables each one for its own vlan

this is the way it is connected in standalone mode  with no problems the vlans in standalone are assigned to a single port but I cant do that with the oc200 because it wont let me change any of the ports in the default vlan

are you saying I should just select all ports in the other 3 vlans then just run a single uplink to the switch?

  @Hank21 

is there anyway to disable the default lan?

i have spent days trying to make the oc200 work and it all comes down to all the ports are tied up by it and you cant designate a port to a different vlan 

my 8411 works fine with muliple wans,vlans and port forwarding in stand alone 

but at this point the oc200 is very much a paper weight 

if i could disable lan1 and then put the oc200 on my own vlans i could make it work

I donr understand what the thinking is of defaulting all your ports to the default vlan and then those ports are not free for a new vlan

  @Clive_A 

yes you have and that dont work I have set the PVID to 20 which is the default vlan

I can get on the internet The problem comes in is port forwarding dont work 

I have a Esxi server with 8 vm's behind this it has 4 nics vm's have different local ip's

I am guessing if I had a Tp-Link switch it may work but I am not going to keep throwing money away If it works in Stand alone it should work with the OC200

just a note that I can ping all the subnets

And yes after 24 hours of trying everything and 10's of resets I am Quite frustrated 

I have called business support and that was a waste of time 

support got it locked up and got me to put a beta firmware on my 8411 which all that did was give me a confidential overlay on the screen