Lost connection after turn on Maxtream on CPE220 + CPE210

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Lost connection after turn on Maxtream on CPE220 + CPE210

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

tepmehatop

2024-03-17 06:27:44

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-03-17

Lost connection after turn on Maxtream on CPE220 + CPE210

2024-03-17 06:27:44

Tags: #MAXtream

Hello everyone and have a great day!

I have CPE220 and CPE210.

- CPE220 configured as AP, and connected to router by lan.
- CPE210 configured as a bridge, connected to laptop by lan.

everything is fine, connected to each other without Maxtream, but as soon as I turn on the Maxtream checkbox on CPE220, the connection immediately disappears.

I mean the connection between them disappears.

If I open the settings CPE210, I can re-survey and I see the CPE220 device in the list and it says Maxtream is enabled, after reselecting, there is still no connection between them.

what could be the problem?

thanks a lot for any help 🙏

1 Reply

Hank21

2024-03-18 08:44:55

Posts: 3673

Helpful: 718

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:Lost connection after turn on Maxtream on CPE220 + CPE210

2024-03-18 08:44:55

@tepmehatop

Can you confirm that the bridge mode you set up is client mode? Normally, for a P2P connection, we set one as AP mode and the other as Client mode. Maxtream will only disconnect non-Tplink devices, it will not block CPE.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

Lost connection after turn on Maxtream on CPE220 + CPE210

Lost connection after turn on Maxtream on CPE220 + CPE210

Information

Voters 0

Tags