EAP225 V3 Outdoor Crashing
Hello, I just installed an EAP225 Outdoor and had the misfortune of seeing the device stop working after less than 24 hours of use. It is necessary to remove it from the socket and replace it to start working again. It is common? What should I do to prevent this freezing from happening again? My infra is as follows: I have a Mikrotik RB4011, connected to an Omada Controller and just an EAP225 Outdoor for now.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Plug the AP directly into the router, not via the controller (assuming you have a hardware controller).
Ensure that your controller's management VLAN is a member of and untagged on the AP port, and as well all SSID VLANs should be present on the AP port and tagged.
I recommend fixing/reserving the IP address of the controller and assigning it via DHCP.
Did you change the default management LAN from 192.168.0.0/24 ?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
The problem actually persists, the router appears to be unable to support around 50 connections and simply shuts down. Bad time to change brands, I was using the Ubiquiti Nano Loco M2 and it worked, it never crashed. I do not know what else to do. Should I claim the warranty?
- Copy Link
- Report Inappropriate Content
Be carefull with the FallBack IP setting of the Access point.
Turn off the fallback ip or you have to give different ips to each Access point (192.168.0.200 , 192.168.0.201 etc)
The access points stop working when they starts without a dhcp server on your network and the fallback ip is same on all.
You have to turn off and on to work again !!!!!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 435
Replies: 4
Voters 0
No one has voted for it yet.