problems OC200 firmware 1.15.2

problems OC200 firmware 1.15.2

problems OC200 firmware 1.15.2
problems OC200 firmware 1.15.2
2024-04-10 17:01:17 - last edited 2024-06-20 09:43:36
Model: OC200  
Hardware Version: V1
Firmware Version:

bonjour

 

je veux changer le firmware de 1.15.2 ver version compatible avec controleur 3.x mais ca ne marche pas j'ais essayer toute les version tous rien

  0      
  0      
#1
Options
1 Accepted Solution
Re:problems OC200 firmware 1.15.2-Solution
2024-06-20 09:43:12 - last edited 2024-06-20 09:43:36

  @Badrtunis 

It is not possible to downgrade the controller to V3 or below after updating it to V5. Every V5 controller has a release note that states this.
Once upgraded to this version of Omada Controller, you will be NOT able to downgrade to version 3.2.14 or below.
You may look into it by going here:Release Note

 

You can install our software controller to manage devices if you want to use the V3 controller.The download link is as follows:Firmware Download

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:problems OC200 firmware 1.15.2-Solution
2024-06-20 09:43:12 - last edited 2024-06-20 09:43:36

  @Badrtunis 

It is not possible to downgrade the controller to V3 or below after updating it to V5. Every V5 controller has a release note that states this.
Once upgraded to this version of Omada Controller, you will be NOT able to downgrade to version 3.2.14 or below.
You may look into it by going here:Release Note

 

You can install our software controller to manage devices if you want to use the V3 controller.The download link is as follows:Firmware Download

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options