OC200 reset!!

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

OC200 reset!!

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
OC200 reset!!
OC200 reset!!
2024-04-20 11:48:16
Model: OC200  
Hardware Version: V1
Firmware Version:

I have bought some Omada devices, so also OC200

 

I started app Omada,  but when scanned it say's  device is offline  so i put in the code,  but it keeps the same.

 

I tried severe times reset,  most of the time it doesn't but sometimes  the led flashed for aboud 2 seconds, no more.

 

How do i start this device?  

  0      
  0      
#1
Options
2 Reply
Re:OC200 reset!!
2024-04-20 16:03:13

  @bonestaak 

 

The controller ideally needs to be connected to a router in order to get an IP assigned--access the 'Users' list on the router to figure out what IP was assigned.  You can then access it at it's assigned IP via https: //the.controller.ip.address:8043 via another device also connected to the same router (or directly connected to the second etherport on the OC200).

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#2
Options
Re:OC200 reset!!
2024-04-22 09:52:03

Hi @bonestaak 

If this was your very first time to set up the OC200, you may refer to the set-up videos and follow the instructions to set up it first.

How to configure Omada Hardware Controller via a Web Browser

How to configure Omada Hardware Controller via Omada App

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#3
Options