Home

Forums

Stories

Knowledge Base

Business Community > Controllers > how to make switch profile without a Native VLAN with controller?

< Controllers

how to make switch profile without a Native VLAN with controller?

how to make switch profile without a Native VLAN with controller?

how to make switch profile without a Native VLAN with controller?

2024-05-29 13:04:14

Posts: 51

Helpful: 7

Solutions: 2

Stories: 0

Registered: 2019-04-20

how to make switch profile without a Native VLAN with controller?

2024-05-29 13:04:14

Tags: #VLAN & Multi-Networks

Model: Omada Software Controller (Linux)

Hardware Version: V5

Firmware Version: 5.13.30.8

In the drop down menu there is NONE but it's always greyed out

How can I make a profile without the native vlan??

For example below I am trying to make a all tagged trunk, 254,1128,52,170 that will communicate with an EAP773

e216c875d03d4ec2b7beaeae12817df6

0

0

#1

1 Reply

2024-05-30 03:30:40

Posts: 3673

Helpful: 713

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:how to make switch profile without a Native VLAN with controller?

2024-05-30 03:30:40

It doesn't support no native VLAN in controller mode currently. If you do want to have a profile without untage network/native VLAN, you can try to create a switch only VLAN with a random VLAN ID but neither gateway nor switch has the port using this VLAN.
Please note that you have to enable the management VLAN for your EAP prior to adding this random VLAN, or you will fail to maange the EAP.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

0

0

#2

2024-05-29 13:04:14

Posts: 51

Helpful: 7

Solutions: 2

Stories: 0

Registered: 2019-04-20

Information

Helpful: 0

Views: 178

Replies: 1

Tags

VLAN & Multi-Networks