Trying to add a second EAP670 V2 (wired)

Trying to add a second EAP670 V2 (wired)

Trying to add a second EAP670 V2 (wired)
Trying to add a second EAP670 V2 (wired)
2024-07-21 18:35:19
Model: EAP670  
Hardware Version: V2
Firmware Version:

I installed an ER707-M2 router and a TL-SG105PP-M2 5 Port 2.5 Gigabit Switch. Everything was running great in the Omada Software Controller. Today I finally got around to connecting the second AP. I ran my ethernet cable down the wall, pulled it through an mounted the AP to the ceiling. Powered up from the switch just fine. Went into the Omada Software Controller and there it is. When I click adopt however it only gives me an option to choose my other AP as the unlink. Both AP's are wired to the switch. What do I need to do here?  This is my first time using anything Omada.

 

Thanks

  0      
  0      
#1
Options
1 Reply
Re:Trying to add a second EAP670 V2 (wired)
2024-07-22 06:10:56

  @Jynx 

Since the AP connects to the root AP via mesh rather via Ethernet backup, you should first check to see if the connection is functioning properly.You can try to turn off the mesh.Kindly visit Settings -> Site -> Mesh.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options