EAP DISCONNECTS DAILY.... NEVER DID THIS BEFORE ADDING THE GATEWAY
I've been running Omada for 7 years now with ZERO issues. 7 AP's 1 OC200 controller. I've upgraded AP's over the years.
EAP620 upstairs / downstairs 3 EAP225 outdoor EAP225 in the shop.
I added a ER707-M2 gateway to my OC200 and started to have issues. I thought the OC200 was maxing out so I upgraded to a OC300 which I am running now.
Daily 1 of my devices will go disconnected.
I have them all statically assigned and even have the Jetstream switches with POE recovery (which I was hoping was automatic).
I login do the POE recovery and everything works again.
I just switched everything to DHCP with Fixed IP address enabled.
What am I missing?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
As mentioned, I had changed it from its default settings (auto) to 80 Mhz, after I changed that back it resolved it issues (at least for me, I haven't put it back to 80Mhz to see if the issues would return).
Anyhow, you can see and change that setting if is select your device for the device list, select "config" and look for "Radios" as shown below in the screenshot. (this setting can be set on per AP basis)
- Copy Link
- Report Inappropriate Content
Sadly TP-LINK is aware of this issue and I was told there would be a fix shortly. I asked them to simply PULL the bad firmware off their update list for now. But I still continue to see my OC300 recommending it.
I have decided, my network is good for now so I just disregard the update noticed. Though the Firmware in the ER707-M2 VPN router still has some issues.
- Copy Link
- Report Inappropriate Content
In my network I have ER8411, OC200, 33 eap's which are still increasing. Most are EAP225 Outdoor hardware version 1 and 3, and 14 EAP225 are connected wirelessly. Everything worked reliably for months until suddenly 6 started disconnecting. I have the radio set to automatic. I didn't see this thread because I didn't have any problems. On all EAP225-Outdoor(EU) I have firmware 5.1.6. In the coming days I will downgrade to 5.1.1 and move to software controller. As I went past the 33 EAP limit the OC200 controller started disconnecting and rebooting, I assume it is faulty.
- Copy Link
- Report Inappropriate Content
theres a new beta firmware for the er707-m2, but i don't think it fixed the problem, even with alos a beta for the 225 outdoor (5.1.7) i think it has problemes, went back to 5.1.1 and everything ist okay again.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 1125
Replies: 24