EAP615-wall wont come online after firmware update failed
Hi.
I recently ran a firmware upgrade on all 3 of my EAP615-Wall APs. One of them failed the update and wont come online anymore.
The LEDs were on but the device was offline on the controller. I decided to do a device reset but the controller still does not detect a new AP even after i deleted the old instance. I have tested connecting it directly to the switch to rule out a cable fault but no luck. It seems like the device is bricked.
Any suggestions for things I can try please?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @SAR-1
Can you see the default SSID of the EAP? You may try the following to fix the EAP unit:
Recovery mode is a useful feature when dealing with firmware corruption, boot failures, or other software-related issues on devices like EAP. By accessing recovery mode, users can attempt to restore the device's firmware to a stable and functional state, resolving any problems encountered.
Here's the guidance:
1. Ensure you have downloaded the latest firmware for EAP from TP-Link's official website.
2. Connect your computer to the EAP and configure a static IP address and subnet mask, such as 192.168.0.100/255.255.255.0.
3. Press and keep holding the reset button of EAP, then connect the EAP to the POE port of the PoE adapter, the LED light will flash, then wait until the LED stable, now you can release the RESET button.
4. Open a web browser and enter 192.168.0.254 in the browser's address bar to access the recovery mode interface and proceed with uploading the firmware.
5. Note that please make sure you are reaching EAP through HTTP, otherwise you'll get refused to connect through HTTPS.
- Copy Link
- Report Inappropriate Content
Hi @SAR-1
Can you see the default SSID of the EAP? You may try the following to fix the EAP unit:
Recovery mode is a useful feature when dealing with firmware corruption, boot failures, or other software-related issues on devices like EAP. By accessing recovery mode, users can attempt to restore the device's firmware to a stable and functional state, resolving any problems encountered.
Here's the guidance:
1. Ensure you have downloaded the latest firmware for EAP from TP-Link's official website.
2. Connect your computer to the EAP and configure a static IP address and subnet mask, such as 192.168.0.100/255.255.255.0.
3. Press and keep holding the reset button of EAP, then connect the EAP to the POE port of the PoE adapter, the LED light will flash, then wait until the LED stable, now you can release the RESET button.
4. Open a web browser and enter 192.168.0.254 in the browser's address bar to access the recovery mode interface and proceed with uploading the firmware.
5. Note that please make sure you are reaching EAP through HTTP, otherwise you'll get refused to connect through HTTPS.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@SAR-1 Good morning, I have the same problem with 2 devices after this update and I cannot restore it. I tried what it says above but to no avail.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 374
Replies: 5
Voters 0
No one has voted for it yet.