Topology changes, EAP with lines and without

Topology changes, EAP with lines and without

Topology changes, EAP with lines and without
Topology changes, EAP with lines and without
2024-09-12 10:38:09
Hardware Version: V1
Firmware Version: 5.14.26.1

Hi. 

 

My topology changes back and forth between these two. I can't find in the manual or topics here if there is any practical difference. The EAP switches between being connected with lines to the rest of the system, to being below without connecting lines. 


Attached a diagram showing how everything is wired. 

 

 

Everything connected with lines

 

without lines

 

setup

  0      
  0      
#1
Options
3 Reply
Re:Topology changes, EAP with lines and without
2024-09-13 02:54:48

Hi  @stole 

 

Maybe the Ethernet cables are not of good quality, or maybe the connection to the switch is not quite stable.

Is the internet affected? How long did you first notice it?

 

  0  
  0  
#2
Options
Re:Topology changes, EAP with lines and without
2024-09-13 16:25:49 - last edited 2024-09-13 16:35:03

  @Vincent-TP 

 

I haven't really noticed anything other than the topology map changing. 

When they are without lines they are still descibed as wired AP under "Mesh". 

I've googled, searched forums and manual, but can't seem to find any explanation as to what it means. 

 

When I ping between router and AP it's on the same level regardless.

 

Within 20 minutes it can go from both with lines, to only one with lines, to both with lines. 

 

 

 

  0  
  0  
#3
Options
Re:Topology changes, EAP with lines and without
2024-09-16 02:19:31
If there is no Internet issue, no need to worry about it.
  0  
  0  
#4
Options