Resetting EAP 110 (Software controller-adopted)

Resetting EAP 110 (Software controller-adopted)

Resetting EAP 110 (Software controller-adopted)
Resetting EAP 110 (Software controller-adopted)
2024-09-20 03:10:11 - last edited 2 weeks ago
Model: EAP110-Outdoor  
Hardware Version: V3
Firmware Version: 5.0.7 Build 20230410 Rel. 69645

Good morning, I have an EAP110 Outdoor Antenna V3 that is running in a SOFTWARE controller which is NOT MINE. My question is, If I reset that EAP Antenna to its factory default using the reset button, can I still be able to use it to my Omada HARDWARE controller? Thank you for the immediate response.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Resetting EAP 110 (Software controller-adopted)-Solution
2024-09-20 07:34:55 - last edited 2 weeks ago

Hi  @raffy_18 

 

Yes. And that's the fastest way to use your hardware controller to manage it .

Recommended Solution
  0  
  0  
#2
Options
3 Reply
Re:Resetting EAP 110 (Software controller-adopted)-Solution
2024-09-20 07:34:55 - last edited 2 weeks ago

Hi  @raffy_18 

 

Yes. And that's the fastest way to use your hardware controller to manage it .

Recommended Solution
  0  
  0  
#2
Options
Re:Resetting EAP 110 (Software controller-adopted)
2024-09-20 08:10:20

  @raffy_18 Another question is, can I use the two Ethernet ports of OC200 (ETH1 PoE IN and ETH2) at the same time (ETH1 PoE IN for 1 EAP Antenna and; ETH2 for ER605) without causing any problem? Thank you again for your response.

  0  
  0  
#3
Options
Re:Resetting EAP 110 (Software controller-adopted)
2 weeks ago
hi, yes.
  0  
  0  
#4
Options