Business Community > Gateways > Omada ignores static routes?
< Gateways

Omada ignores static routes?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada ignores static routes?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada ignores static routes?
Omada ignores static routes?
2024-12-09 13:44:07 - last edited 2024-12-13 01:14:27
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version:

I have a functioning omada setup with gateway switch and eap. For security reasons som IPs must be routed through an extra gateway. So I set up a static route let's say

 

192.168.3.0/24 next hp 192.168.100.220

 

But when I traceroute for example 192.168.3.4 then next hop is the address of the gateway and it doesn't hop to 192.168.100.220 at all. Only ***. It seems like it's ignoring all my static routes.

  0      
 
  0      
 
#1
Options
2 Accepted Solutions
Re:Omada ignores static routes?-Solution
2024-12-10 01:00:20 - last edited 2024-12-13 01:14:33

Hi @MVZ_MUDr_C 

Thanks for posting in our business forum.

Not enough information for diagnosis.

What have you done to verify that *** is not the firewall you defined? Wireshark? Traffic monitor on that firewall?

Without that static route, what are the differences between the route you had and now with the static routing?

 

Aint you suppose to traceroute the external network like 8.8.8.8?

Recommended Solution
  1  
  1  
#2
Options
Re:Omada ignores static routes?-Solution
2024-12-12 12:29:31 - last edited 2024-12-13 01:14:27
The hop destination was behind vpn.I din't route all the necessary IPs through this vpn. So delete this thread.
Recommended Solution
  0  
  0  
#3
Options
2 Reply
Re:Omada ignores static routes?-Solution
2024-12-10 01:00:20 - last edited 2024-12-13 01:14:33

Hi @MVZ_MUDr_C 

Thanks for posting in our business forum.

Not enough information for diagnosis.

What have you done to verify that *** is not the firewall you defined? Wireshark? Traffic monitor on that firewall?

Without that static route, what are the differences between the route you had and now with the static routing?

 

Aint you suppose to traceroute the external network like 8.8.8.8?

Recommended Solution
  1  
  1  
#2
Options
Re:Omada ignores static routes?-Solution
2024-12-12 12:29:31 - last edited 2024-12-13 01:14:27
The hop destination was behind vpn.I din't route all the necessary IPs through this vpn. So delete this thread.
Recommended Solution
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 468

Replies: 2

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.