Please enable LAG/LACP support for business routers like ER7412-M2
 This repeated request has been merged into the main thread [FEATURE REQUEST]: ER8411 - add LAN LAG (Link Aggregation) feature. Please vote on the main thread.
Please enable LAG/LACP support for business routers like ER7412-M2
The multi-gigabit business gateway routers like ER8411 & ER7412-M2 should support LAG and/or LACP with the Omada Ethernet switches. Otherwise it is difficult to pass on the bandwidth other than having an extra multi-gigabit switch between your gateway and switch, just to add LAG/LACP support.
I was a bit shocked that Omada's top end gateways don't appear to support and aggregation with Omada's own switches!
Please enable LAG/LACP support for business gateways like ER7412-M2.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Please enable this I have ER7412-M2 and this allow me to expand my network with this Ecosystem
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Come on TP Link, this is a feature that should have been there from day on. I purchased it expecting I could configure LAG on both 2.5Gbps and SFP ports. Surprised when I found out it did not support it. Please give this serious consideration as it would take this router to the next level.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
There is another post with the same feature request. To avoid splitting the votes, I have merged this post with the other one. Please focus the discussion on that thread going forward.
[FEATURE REQUEST]: ER8411 - add LAN LAG (Link Aggregation) feature
- Copy Link
- Report Inappropriate Content
Information
Helpful: 35
Views: 4193
Replies: 18
Voters 35
