How to reset a port ?

How to reset a port ?
How to reset a port ?
2014-03-28 08:21:48
Region : Argentina

Model : TL-SG5428

Hardware Version : V1

Firmware Version :

ISP :


Hello !

I cannot find anything in the manual to reset a port.

I see in the STP/interface configuration, that the port is disabled and do not know how
and where to change.

If I connect my WLAN-AP, OTHER ports on the network are massively disturbed.
If I disconnect the WLAN-AP, everything becomes ok. This also happens, if I
connect the WLAN-AP to another port.

I haev another WLAN-AP at another port, which works. For the problem device,
I also tried to change the access mode to trunk - bis this did'nt change the prob.

I cannot diagnose the situation, because the switch itself becomes unaccassible.

Any help would be great !

Thanks anyway and best regards,

mabra

Model: SG3109 [not listed in any of teh forums :-( ]
0
0
#1
Options
1 Reply
Re:How to reset a port ?
2014-04-15 16:37:37
You use the STP, that's a protocol which could disable or enable the port automatically, just disable the STP feature and do not use that, the problem would be solved.
0
0
#2
Options