Need help setting up vlan tagging from tp link switch to edgerouter
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Need help setting up vlan tagging from tp link switch to edgerouter
Tags:
#VLAN & Multi-Networks
Hello, I setup vlans so what I did in the edgerouter x:
- created new vlan 30 interface in edgerouter x
- made switch0 vlan aware and in eth2 made vid 30
- made a DHCP server (with subnet 192.168.249.0/24)
And then in the tp link switch (tl-sg108e):
- in 802.1Q VLAN, change its vlan id 1 to remove port 1, and add vlan 30 for port 1
- in 802.1Q PVID, change port 1 to pvid 30
When restarting Internet connection from Xbox, it says cant find DHCP server (basically it failed)
I'm not sure what I'm doing wrong, by the way thanks for reading
1 Accepted Solution
Re:Need help setting up vlan tagging from tp link switch to edgerouter-Solution
Thanks for posting in our business forum.
Two basic guides for the VLAN.
Common Questions About 802.1Q VLAN
It should be untagged and your uplink for VLAN 30 is not included.
Re:Need help setting up vlan tagging from tp link switch to edgerouter-Solution
Thanks for posting in our business forum.
Two basic guides for the VLAN.
Common Questions About 802.1Q VLAN
It should be untagged and your uplink for VLAN 30 is not included.