@arrmo 

 

If you have an Omada controller, you just need to forget the old router, then select the type of router in the internet settings, follow the wizard. Make a backup before doing this, if you make a mistake, just restore and try again.

Sounds great, thanks! Will do that - and report back. I am changing out the router, also moving from a SW controller to OC200 ... router or controller first? ;). Thanks again!

  @arrmo 

 

first set up the new router with IP in stand alone if you are using something other than the standard IP 192.168.0.0/24 once you have run the wizard you can adopt the router

 

Thanks! Will report back :)

OK, I went to do this, but ... how to replace the current router to do this? Asking because I can't have 2 (upstream) routers in parallel ... right? So how to actually make the swap? Thanks!

  @GRL That works, thanks! It was the forget part I needed to do first LOL. Almost all good now ... just a couple odd things not working yet (after adopt, reboot),

1) Cloud access, shows disconnected. Off, back on. Nope. Odd.

2) Firmare updates, it complains when trying to get the list.

 

It's almost like DNS isn't working, but many other things do work. Very odd.

 

Thanks again.

Found it! Had to reboot the (SW) controller, after replacing the router. Thanks!