Bug Report: Unable to Disable LEDS after firmware update
After upgrading to switch firmware 1.0.10 Build 20250428 Rel.61524, the port LED's that were off were re-enabled. Even after doing a switch reboot with either using site setting (which specify LED's to be off) or setting the port leds to be off in the switches config menu (through an Omada OC300 with firmware 5.15.20.391.29.7 Build 20250514 Rel.59723), the LEDS remain on.
No matter how I try to reconfigure the switch, I can no longer turn the port LEDs off.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
PKeithM wrote
I did some more testing. The problem appears to be limited to the link activity LEDs only on all the ports (including the SFP+ ports).
The other LEDS (POE, System) can be turned off and on with the config page.
Keith
This issue has been reproduced in our lab.
A fix will be released soon. Please pay attention to the new release for this model.
- Copy Link
- Report Inappropriate Content
PKeithM wrote
After upgrading to switch firmware 1.0.10 Build 20250428 Rel.61524, the port LED's that were off were re-enabled. Even after doing a switch reboot with either using site setting (which specify LED's to be off) or setting the port leds to be off in the switches config menu (through an Omada OC300 with firmware 5.15.20.391.29.7 Build 20250514 Rel.59723), the LEDS remain on.
No matter how I try to reconfigure the switch, I can no longer turn the port LEDs off.
Will inform the test team to review this feedback.
I will update you as I am updated.
- Copy Link
- Report Inappropriate Content
I did some more testing. The problem appears to be limited to the link activity LEDs only on all the ports (including the SFP+ ports).
The other LEDS (POE, System) can be turned off and on with the config page.
Keith
- Copy Link
- Report Inappropriate Content
PKeithM wrote
I did some more testing. The problem appears to be limited to the link activity LEDs only on all the ports (including the SFP+ ports).
The other LEDS (POE, System) can be turned off and on with the config page.
Keith
This issue has been reproduced in our lab.
A fix will be released soon. Please pay attention to the new release for this model.
- Copy Link
- Report Inappropriate Content
@PKeithM
I'm facing the same issue but it was impacting ALL LEDs on my switch. I did a "Force provision" and the setting applied fully. Sounds like they have an issue with applying the setting... not the setting itself.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 374
Replies: 4
Voters 0
No one has voted for it yet.