Ever since the very first 1.3.0 beta, then following on to 1.3.0 official, then 1.3.1, and now the 1.3.2 released on controller yesterday, my ER8411 temperature as reported to the controller is around 9c higher than it reports in its standalone GUI

As of 1.3.2 yesterday, it is now 11c higher than in standalone

My IT rack is in a temperature controlled room with lots of good airflow.  

To test, i factory reset the router (running 1.3.2), added the same basic config as i use when adopted but in standalone mode.

CPU Temperature and Board Temperature report 47c / 49c after being left to settle for an hour

When adopted, after letting settle for an hour, we only get a single temperature reading, and mine is sitting at 59-60c.  Its fans are still off.

Is this expected or is this a bug ?

Previously on 1.2.3 and earlier, temperature reported to the controller was always exactly the same as whichever was hottest (cpu / board) in standalone.