VLAN Wifi Trunk SSID
I'd like to create an SSID called 'backhaul' on the ER706W and pass traffic to it from a DDWRT based WiFi repeater bridge for VLANs 1.3,4. Is it possible to setup the backhaul SSID on the ER706W to accept traffic from multiple VLANs and/or have the tags preserved from the DDWRT WiFi repeater bridge?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
We have not tested anything like this.
You can configure the SSID with only a single VLAN ID.
Trunk is more of a physical port term. Not for the wireless.
- Copy Link
- Report Inappropriate Content
We have not tested anything like this.
You can configure the SSID with only a single VLAN ID.
Trunk is more of a physical port term. Not for the wireless.
- Copy Link
- Report Inappropriate Content
Yes, I have it working with vlan1, but I was hopping to also pass vlan2 and vlan3 tags as well over the backhaul. The er706w has a port that is connected via Ethernet that has tagged traffic for vlan1, vlan3, vlan4.
I just don't have the ability to physically connect the two Wi-Fi ends and was hoping for a way to bridge the two side with Wi-Fi.
- Copy Link
- Report Inappropriate Content
codechurn wrote
Yes, I have it working with vlan1, but I was hopping to also pass vlan2 and vlan3 tags as well over the backhaul. The er706w has a port that is connected via Ethernet that has tagged traffic for vlan1, vlan3, vlan4.
I just don't have the ability to physically connect the two Wi-Fi ends and was hoping for a way to bridge the two side with Wi-Fi.
That's not possible as explained previously.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 229
Replies: 3
Voters 0
No one has voted for it yet.