Getting to many log entries

Getting to many log entries

Getting to many log entries
Getting to many log entries
2 weeks ago - last edited a week ago
Model: TL-SG2428P  
Hardware Version: V5
Firmware Version: 5.20

Hardware:

OC200

ER-605

SG2428P v5.20

AP (multiple).

 

For some unexplained reason - I'm getting an email that log capacity reaching to its limit.

I don't know if it a setting i've change, or the fact that I get not email notification, but in less than a week from my last deletion of all log entries, it gets filled back again.

 

 

 

  0      
  0      
#1
Options
2 Accepted Solutions
Re:Getting to many log entries-Solution
2 weeks ago - last edited a week ago

  @guyd2 

 

By default (and in my opinion) the log has far too many entry types enabled by default which just cause unnecessary clutter in the logs for each site.  I turn a huge amount of them off for this exact reason.

Main: ER8411 x1, SG3428X x1, SG3452 x1, SG2428LP x1, SG3210 x1, SG2218P x1, SG2008P x3, ES208G x1, EAP650 x6 Remote: ER7206 v2 x1, ER605 v2 x3, SG2008P x2, EAP650 x2, ES205G x1 Controller: OC300
Recommended Solution
  1  
  1  
#2
Options
Re:Getting to many log entries-Solution
a week ago - last edited a week ago

  @guyd2 

You can fine-tune the log system. 

Recommended Solution
  1  
  1  
#3
Options
2 Reply
Re:Getting to many log entries-Solution
2 weeks ago - last edited a week ago

  @guyd2 

 

By default (and in my opinion) the log has far too many entry types enabled by default which just cause unnecessary clutter in the logs for each site.  I turn a huge amount of them off for this exact reason.

Main: ER8411 x1, SG3428X x1, SG3452 x1, SG2428LP x1, SG3210 x1, SG2218P x1, SG2008P x3, ES208G x1, EAP650 x6 Remote: ER7206 v2 x1, ER605 v2 x3, SG2008P x2, EAP650 x2, ES205G x1 Controller: OC300
Recommended Solution
  1  
  1  
#2
Options
Re:Getting to many log entries-Solution
a week ago - last edited a week ago

  @guyd2 

You can fine-tune the log system. 

Recommended Solution
  1  
  1  
#3
Options